• Join the A7X Discord!

    We're updating the community and moving all social content from the community to the Discord. All lessons related conversations will still take place here though! Join the Discord below and view the full announcement for more details

    JOIN THE DISCORD VIEW THREAD

Help with schecter demon 6

G

Guest

Guest
So my problem is that if I try to do a whole step bend at the 15th fret and just play a note on the 15th fret it gets cut out and doesn’t sustain at all how do you fix this is it a dead note? Also I have the Crimson red burst version of the guitar
 

Noah Berends

Campfire Attention Holder
  • Nov 11, 2019
    408
    86
    Fort Wayne, IN
    13
    It sounds like some routine maintenance is needed. Your action at the bridge end may be too low, or the neck has too much anti-bow. and this is a totally normal thing to happen over time. Guitar center techs can do it, or if you have the time and the tools you can find some resources online on how to set up truss rod/bridge height. The advantage of learning it yourself is that you can always do your own setups on your guitars and set them up *exactly* how you like them to be. But there is a learning process at the beginning.
     

    Ed Seith

    Supreme Galactic Overlord
    Staff member
    Legend+
  • Nov 11, 2019
    3,882
    15
    6,603
    54
    Marana, AZ USA
    soundcloud.com
    35
    To add to Noah’s excellent answer, look at where the neck meets the body. You say that the issue is at the 15th fret. On many guitars, that’s right around where the neck meets the body. If that’s the case, you may need to raise the bridge slightly. Typically a truss rod adjustment would be if the issue was presenting itself closer to the headstock, like the first half-dozen frets or so.
    But also, if it was a bridge thing, it would usually affect not just the 15th fret, but all of the frets above it, as well. It’s possible your 16th fret runs a touch high, and that raising the bridge a little will account for it. If you’re set on the current action, a tech can examine and level/dress your fretboard. That can be a bit pricey, though.