Rack Setup

[Cade Zwick]

Recently purchased a rack setup. Asking for any help/tips on signal order, etc. I can’t link an image here at the moment, but i can list the equipment if i get any bites.

Rage and Love,

Cade Zwick

 

[Ed Seith]

I haven’t seen a fridge like that in a long time. Some of the gear I don’t really recognize, but I’ll give you the basics.

it should all plug into the power conditioner (top) so you can power on and off with one switch. It’s also a surge protector, vital in shithole club environments with questionable wiring.

The tuner should probably go first, followed by the Hush. Then you put your amps in there. If they have effects loops, you go to the multi-effect units, then the delays followed by reverbs. Might want the BBE units after the multi effect units but you can try before and see if you like that better.

is there a big foot pedal to control it via midi and such? If not, you really kinda need one.

 

[Ed Seith]

Okay, so that Marshall is just a pre-amp, so no effects loop. Everything I said to put in the loop goes after the Marshall. The big guy at the bottom is the power amp and that's last, with the cabinets being plugged into that.

If you were to swap the Hush and the JMP, you could wire it top to bottom and be fine.

 

[Cade Zwick]

the only issue i have is the Marshall only has an input on the front, and the hush in/outputs are located on the back. is it possible to run everything through the 16 channel mixer on top?

 

[Cade Zwick]

maybe i should go, hush-tuner-marshall?

 

[Ed Seith]

Maybe? Can't hurt to try. My first rig had a Fender M80 head that only had a front input. I had to leave a space empty above it and use an angle jack to really make it work, but it did.